| Main > Main Forum |
| Trouble with my IPAC, little advice? |
| (1/2) > >> |
| releasedtruth:
Well, I'd made sure that all my controls were wired up correctly, but 1sw7 and 1sw8 on the IPAC won't register a key press no matter what's connected. That I certainly blame on the hardware. Secondarily, I'm noticing that not all my key presses are being registered and sometimes they're delayed. This is pretty much in any game. I checked all the wiring and things are tight so... Computer runs sliky smooth, etc. I'm perplexed, anyone else been here? Thanks GT |
| leapinlew:
I would figure in the year 2176 we wouldn't be using Ipacs. ;D Have you done any troubleshooting? Such as - have you tried to run any cables specifically on a known good switch on a dedicated ground to sw7 and sw8 on the ipac? Looking at your picture, your wiring looks nice and clean: The grounds are soldered and the rest were quick connects? My previous issues that were similar to yours involved a faulty ground. It would sometimes register and any buttons after the ground in the daisy chain wouldn't work at all. Tracing the problem I was able to determine my ground didn't have a proper connect and the ipac was fine. |
| releasedtruth:
Haha, you're right! I think in 2176 we use IPAC 5000s, but I didn't bring one back from the future sadly. That's a good point with the ground. I did the single wire for cleanness sake, but I never thought it would cause me problems. I'm gonna try that passmark program next. Andy at Ultimarc is seriously quick to respond, great service thus far. I'll update as I figure this out. Other than the overrunning targets and some delayed presses, things are good! GT |
| AMDman13:
Correct me if I'm wrong but aren't sw7 and sw8 the inputs that aren't implemented in Mame by default? I know I had to set these up in (tab) settings? Of coarse this doesn't account for your delayed button presses. |
| Mark70:
I had ipac troubles. It wouldn't shift. And some button press issues. Turned out I had a short. I bent one of the quick connects installing the CP. If I remember it was shorted to the common on another button or something, so it was basically registering a held down key all of the time. It was on one of the higher numbered buttons on the 2up side, so it was little used and I didn't notice it. |
| Navigation |
| Message Index |
| Next page |