Software Support > PowerMAME

setup help

<< < (2/2)

MYX:

--- Quote from: gamenut on October 14, 2006, 05:12:37 pm ---Also, can i set the cfg path to my mamewah cfg?

--- End quote ---
yeah this was another issue. All the resolutions I had set with MW did not show up when I used PM32 as the MAME source.

gamenut:
Don't know if you noticed the other post about me getting PM to work. FYI
But after transfering everything over to another computer,nothing worked. I lost something somewhere.
So i just started from scratch, using only rom/snap/cab/and marquee  folders from old cfg's.
Now the only problem i am having with PM is only half the led board is working.
It works fine with AtomicFE.
But i can't get the one side of the board to work with PM.
And onward i go! 8)

Navigation

[0] Message Index

[*] Previous page

Go to full version