Main > Main Forum
Looking for some PINK T-Molding
(1/2) > >>
8way:
Anyone know were I can find some 5/8" pink t-molding?

UPDATE!!! I’m a moron it’s ¾” not 5/8”.
daywane:
5/8 ?!
darn you might be out of luck.

some of us in buy/sell/trade went in and www.dreamarcades.com
made a special run for us. 3/4 inch

I bought 2 sets. only used 1 very nice on my MS pacman
YEP! just looked . He has 3/4 still and pink Joy sticks, Pink buttons but nothing I see in 5/8
Aurich:
It wouldn't be that hard to trim the extra 1/8" with a sharp exacto or the like if you can't find an alternate source.
daywane:

--- Quote from: Aurich on October 11, 2006, 12:38:30 pm ---It wouldn't be that hard to trim the extra 1/8" with a sharp exacto or the like if you can't find an alternate source.

--- End quote ---
yes it would
take 1/2 of that off each side
8way:
WOW! Thanks daywane for the Dream arcades link. Can’t believe I missed that site. I’m building a bartop for my wife and I needed pink buttons and a pink Ball Top joystick. All I could find before were the Sanwa sticks and snap in buttons, this would have made it a lot more difficult considering I’m using 5/8 wood.

UPDATE!!!

Somehow I got it stuck in my head that I was using 5/8” wood, when actually I was using ¾”. So problem solved. No trimming needed, definitely a good thing cause I was not looking forward to attempting to trim it.

Does anyone know if a 1/16" slot cutting bit will be ok for the pink t-molding from dreamarcades.com?

By the way this will be my first MAME project. I will post pictures soon. Progress is slow whish I didn’t have to work.
Navigation
Message Index
Next page

Go to full version