Main > Main Forum
Suzo Inductive - how to connect?
<< < (5/5)
TOK:

--- Quote from: LarsDK on November 02, 2006, 03:08:11 pm ---
--- Quote from: Level42 on October 22, 2006, 02:37:10 pm ---Hi Lars,

Did you receive the connectors ?


--- End quote ---

Yes, it arrived yesterday.
Check your pm.

Anyone reading this with knowledge of I-PACs:
Can you tell me how I can draw 5v from the board?
Seems Andy told Level42 that you can do that. But I am unable to locate any 5v (or something similar) on the I-PAC.

Thanks,


--- End quote ---

I have an IPAC that I purchased about 2 months ago that also doesn't appear to have any provision for a 5v connection. I used the red lead from an unused power connector on the PC to power my Suzo's. They work great.
Grasshopper:

--- Quote from: LarsDK on November 02, 2006, 03:08:11 pm ---Anyone reading this with knowledge of I-PACs:
Can you tell me how I can draw 5v from the board?

--- End quote ---

You can draw +5v from one of the header pins normally used for connecting LEDs.



If you don't have a suitable connector and don't want to solder directly onto the pin then you can hack a CDROM drive audio cable.
LarsDK:
It works. It actually works! Woohoo  :cheers:  :applaud:

BIG thanks to everybody helping me out on this one.

Cheers!
Navigation
Message Index
Previous page

Go to full version