Main > Main Forum

Cutting diamond plate

Pages: << < (2/3) > >>

_) (V) (-):

Your best bet would be to use a shear press.

Would cut through 8 ft of 1/4 thick material in about 1 second.


Perfect straight cuts too. Might be cheeper (than burning up blades) and quicker to find someone in a metal shop to do this for you.



Jetto Funk:

I was thinking of doing diamond plate for my cab but I dunno where to find it *Home depot and lowes and strikes so far*
How much did you pay for it?

sealslayer:

Only place I could find that sells it is a small hardware shop,none of the main chain stores over here seem to sell it, its not cheap though,

GoPodular.com:

You can get pieces suitable for smaller panels (like ours) at Menards.

dudebozo:

i remember seeing someone how had diamond plate as like a kickplate on their mame cabinet.  i asked him where he got it cause it seems like no where around where i live carries it.  this is the website that he gave me.  he said they were pretty dang good. 

http://www.cutsmetal.com/index.htm

Pages: << < (2/3) > >>

Go to full version