| Main > Main Forum |
| Cutting diamond plate |
| << < (2/3) > >> |
| _) (V) (-):
Your best bet would be to use a shear press. Would cut through 8 ft of 1/4 thick material in about 1 second. Perfect straight cuts too. Might be cheeper (than burning up blades) and quicker to find someone in a metal shop to do this for you. |
| Jetto Funk:
I was thinking of doing diamond plate for my cab but I dunno where to find it *Home depot and lowes and strikes so far* How much did you pay for it? |
| sealslayer:
Only place I could find that sells it is a small hardware shop,none of the main chain stores over here seem to sell it, its not cheap though, |
| GoPodular.com:
You can get pieces suitable for smaller panels (like ours) at Menards. |
| dudebozo:
i remember seeing someone how had diamond plate as like a kickplate on their mame cabinet. i asked him where he got it cause it seems like no where around where i live carries it. this is the website that he gave me. he said they were pretty dang good. http://www.cutsmetal.com/index.htm |
| Navigation |
| Message Index |
| Next page |
| Previous page |