Main > Main Forum

T-Molding

(1/2) > >>

gajaman:
I've received my order of T-molding from happs and am surprised how small the bottom part of the T is.

The width of the bottom is only about 1.5 - 2mm and I can't find a slot cutting router bit small anywhere near small enough. The best supplier in the UK I could find on-line is www.trendmachinery.co.uk/profinder/ but they don't do anything below 3mm.

Any advice?

darkmanx:
alot of people use cutting or grinding discs in a dremel tool or similar tool. i used a router bit and its too big but dont worry...hot glue will hold it in place perfect if you go that route. either way works fine.

jerryjanis:
What about this guy?

http://www.t-molding.com/cp/cgi-bin/cp-app.cgi?usr=2305724&rnd=8744294&pg=store&sub_pg=prod&ref=20

darkmanx:
$31.00.....ouch

JustMichael:
Less ouch: http://www.routerbits.com/cgi-routerbits/sr.cgi?968180030_22805+105
I saw this link quite a while ago and saved it for when I build a cab from scratch.

Navigation

[0] Message Index

[#] Next page