Main > Main Forum

Did I just buy a Large paper weight?

Pages: << < (2/4) > >>

Q*Bert_OP:

if the cab has a U5000 monitor, all that you *should* need to do is unplug one connector, and put it on the other...but I have seen some U5000s that use soldered in jumpers, which are also not hard to install...

johnnya:

Blitz can be used with either a medium or a standard resolution monitor.  The dip switches are to tell the game what kind of monitor is hooked up to it so it will generate the correct frequency or whatever.  If you run the wrong one on your monitor, chances are you'll ruin it.  No, this doesn't answer your question.

Grauwulf:


--- Quote from: Panzer on September 07, 2006, 10:11:04 pm ---So despite the arcadevga that mentions a 25khz mode i am screwed? Thansk all.

--- End quote ---

I would e-mail Andy and get his take on it, you may still be abel to make it work.

RayB:

I wouldn't use that to hold down paper. Not unless you're used to keeping your paper work on the floor.  You essentially have a nice cat perch... or a patent pending "Space Consumer"TM


Kremmit:

A lot of 25k monitors are "dual res", and can be switched to 15k.  Find out what model your monitor is.

IIRC, Andy said the 25k modes on the new avga were pretty much only good for games that originally used 25k monitors.  I could be wrong, though.

Pages: << < (2/4) > >>

Go to full version