| Main > Buy/Sell/Trade - non-retail |
| Replacement P360 actuators (better diagonals) $5 now! See kowal's posts, page 2. |
| << < (14/16) > >> |
| hypernova:
Bleemus, what's ponyboy's paypal so I can send my money to him. I've yet to hear from him, and I'd rather pay now so I don't have to keep remembering later. And yes, getting those things on is tight. Do what bleemus stated to get them on, careful not to mess up the outside cylinder. |
| squirrellydw:
How do I get some of these?? |
| bleemus:
--- Quote from: hypernova on November 02, 2006, 08:03:33 pm ---Bleemus, what's ponyboy's paypal so I can send my money to him. --- End quote --- sales@rollieelectronics.com --- Quote from: squirrellydw on November 03, 2006, 10:12:41 am ---How do I get some of these?? --- End quote --- PM Kowal or send him an email at kowal@itcom.pl with your order. |
| quarterback:
What size are people getting? 13,5mm, 13,6mm, 13,7mm, 13,8mm or 14mm? |
| RobotronNut:
--- Quote from: bleemus on November 02, 2006, 09:02:52 am ---NOTE: They might go on a bit snug to the joystick shaft, but if you just spin them around to put them on, it knocks the burrs off and they fit perfectly. --- End quote --- there can be slight variability among shafts. IIRC, my slikstik stainless steel shafts were a little thicker than my NOS wico balltop shafts. you can use a little steel wool or ultra-fine sandpaper to touch up the shafts, if necessary. |
| Navigation |
| Message Index |
| Next page |
| Previous page |