| Main > Buy/Sell/Trade - non-retail |
| Replacement P360 actuators (better diagonals) $5 now! See kowal's posts, page 2. |
| << < (5/16) > >> |
| kowal:
--- Quote from: RobotronNut on September 11, 2006, 01:41:20 am ---this appears to be a custom balltop shaft for the happ p360. i just found this page on kowal's website. kowal - do you sell these balltop shafts for the happ perfect 360? --- End quote --- first time I have to take back my SUZO handles (I have 2 months delays:P). then I will make series MODkit P360. I can make also only actuators (4-5$) |
| hypernova:
Time to start using notepad...had a post all set, then opened up the emachineshop program, and it loaded emachineshop's page. Lost my whole post. Shorter version: I did my own quote using emachineshop with stainless steel and the original dimensions. Don't forget that the inner diameter of .375" accounts for most, if not all the 360 joysticks, and that the tolerance of the ID needs to be .001". (See the referal threads in original post for more info on this.) The OD I am assuming doesn't need to be accurate, so I left that as default. 30-$270 - $9.00 each 50-$350 - $7.00 each 100-$510 - $5.10 each As it stands, there is only enough demand for around 30. I could potentially see getting around 10-20 more, but unless there's a HUGE spike in demand, I wouldn't get any more than 50 of them. --- Quote from: kowal on September 11, 2006, 09:53:30 am ---I can make also only actuators (4-5$) --- End quote --- How is your price so low, kowal? |
| kowal:
--- Quote from: hypernova on September 12, 2006, 07:35:29 pm ---How is your price so low, kowal? --- End quote --- Manufacturers count most costs for preparing production (set turning-lathe). It's nevermind if parts for production is simple or not. You pay for set machine, other costs (production) are very low (almost nothing). I don't have these costs for preparing production :P |
| somunny:
For ten dollars or under, you can count on me for two. |
| bleemus:
I would think that the outer diameter would need to be closer than the inner. Since the spring and the e-clip on the stick end up holding it pretty well in place on its own. Just as long as it is big enough, should be ok. I mean, it would be good if they both were within .001, but i don't think that the inner diameter one would be the one to worry about... but I could be wrong. The outer diameter has as 15 degree difference for a .5mm (or 0.019 inch). So that seems pretty important to me. Maybe we can have kowal make a bunch and send them to someone in the US to distribute? Also, on emachineshop, I noticed that even though the cost/unit is higher for aluminum over steel, the lathe cost ended up coming with a smaller quote for the aluminum; just something to check out. |
| Navigation |
| Message Index |
| Next page |
| Previous page |