| Main > Main Forum |
| Perfect 360 Diagonals |
| << < (2/4) > >> |
| RobotronNut:
--- Quote from: hypernova on September 04, 2006, 10:01:54 am ---Where can I get these 13.5 mm actuators? --- End quote --- i had them made at a local machine shop. they charged me $20 each. see this thread for the specs to give to your machine shop. note that i chose the 0.541" outside diameter over the 13.5mm ones. i can't stress enough how great this mod has been. my all-time high score and my average scores in robotron have doubled since i modded my P360s. (note that i also installed shorter shafts and lighter springs. these also make a big difference. see the link in my signature for details). |
| kowal:
I can make but I have problem. My friend smashed leg. I I wait already month on my handles to Suzo UIC. I am bad that this it is late but I will not advise on this anything. This will recover it will make :P |
| hypernova:
--- Quote ---i had them made at a local machine shop. they charged me $20 each. --- End quote --- So you spent $120 for 6 total pieces? We have a lathe at work...I'll have to find out if it's for metals, and can be that precise, then figure out where to find SS rods if it is, so hopefully I can save some major moolah. |
| kowal:
for 20 $? very road. it for this price was it been possible to have full modkit |
| RobotronNut:
--- Quote from: hypernova on September 04, 2006, 03:42:07 pm ---So you spent $120 for 6 total pieces? --- End quote --- yes. $20 each is a custom, one-off price. if you made a modest quantity, the price should be much lower. of course, you'd only need one actuator per joystick, if you trust the results of my experiments. my recommendation would be to just go with the 0.541" ones; i think most people would be pleased with them. |
| Navigation |
| Message Index |
| Next page |
| Previous page |