| Main > Main Forum |
| 1 1/4" holes for Joysticks ... |
| (1/1) |
| Czapala:
I have read that you only need to drill 1 1/8" holes for (Happ) joysticks. (just like the buttons) Is there anything wrong with 1 1/4"? It will be in 3/4" MDF mounted from the bottom with slighty less than 1/4" routed from the bottom. I was just thinking of more room for the stick. But seeing as how I have not actually built one of these things yet, I guess I may be over thinking again. |
| ahofle:
I have 1 1/4" holes. Works perfectly for me, no rubbing. And the dust washer completely covers the hole in all directions anyway. |
| bleemus:
1 1/8 was fine even for my P360 that was mounted slightly off center. So just as long as the stick you are using doesn't have a really long throw, 1 1/8 will be just fine. I agree with afhole though, 1 1/4 shouldn't hurt anything since the dust washer covers the whole shebang anyway. |
| Navigation |
| Message Index |