Main > Project Announcements

-Projected Nexus- It's been a while

<< < (12/12)

releasedtruth:
Okay, I should have done this ages ago, but I never quite found the right method. The plexi panels are 1/8" and I have some flat top 3mm leds that will work great if I can find a way to make it look good. Attached are some pics. My first thought was to notch the plexi a little, then secure the leds into the 2 slots, but I don't know where to run the wiring cleanly or how to mask the front face of the led that will be visible. You can see how the CP fits into the opening. There's room for wires, but not a very clean solution. Drilling into the face is an option, but that pristine kitchen grade lam may not like it.


Any ideas would be appreciated, lighting or wiring methods.

releasedtruth:
I never did post my adjustments to the marquee retainer and lit panels. The retainer is now angle aluminum, looks much better. Lit the panels with a pair of 3mm leds. Not super bright or distracting.

Navigation

[0] Message Index

[*] Previous page