Main > Main Forum
Slot Depth?
NickC:
How deep should a slot be to use t-molding?
IG-88:
I'm no expert but I would measure the length of the verticle part of the "T" and then cut the depth accordingly. Maybe make a few shallow cuts to begin with and test fit one end of the molding (in a out of site spot) to see that it sits down flush.
Xphile:
I'm gonna make a wild guess at 3/8ths of an inch or a fraction deeper..:-)
FractalWalk:
I'm no expert either, but I don't think it really matters as long as it as at least the depth of the "T". I just cut mine about 5 mins ago using the bushing on the arbor bit as the limiter. It was deeper than I needed but everything fit just fine.
radiator:
would it really matter if you acidently went deeper?
personally i wouldn't have thought so...