Front End Support > MaLa Frontend

MaLa v1.0 RC7a available

<< < (8/8)

swindus:

--- Quote from: Samanai on August 24, 2006, 11:30:03 am ---Loadman, yes it does.  In fact, it recognizes them both in MALA controller/joystick/check as well, but only recognizes J1 as J1 in Set 1 and J2 as J1 in Set 2.  There is never an ability to either (a) recognize both in the same Set in the check mode, or (b) have the J2 joystick figure be activated in either Set in the check mode (always shows up as the dotted line figure; therefore the J2 showing up as J1 in set 2).  Make sense? 

Thanks Swindus.  Your work is always much appreciated.

--- End quote ---

I checked it and for me it works like it should.
Some explanation on the joystick config and sets:

J2 is not the second joystick, it is the second stick (axis z and r, for example on a gamepad) on the same joystick as J1 (axis x and y).  ;)

So the complete settings of joystick set 1 are related to the first connected joystick only and the joystick set 2 is related to the second connected joystick. I think the GPWiz will provide two axis (x and y) so you can only use J1up, J1down, J1right and J1left with it. But you can use these values/settings in both joystick sets for each GPWiz ....

Or in other words: each joystick in MaLa can handle up to 4 axis (x,y,z and r), 4 pov directions and 12 buttons and this is called a joystick set.

I hope this helps and works!

loadman:
Thanks Swindus :-)

--- Quote ---So the complete settings of joystick set 1 are related to the first connected joystick only and the joystick set 2 is related to the second connected joystick
--- End quote ---
This is where is I got pop-up error windows (sometimes) yesterday

Today it works without errors.  ??? Could it be that I drunk too much on Friday night?   :D

Samanai: Did you try SET2 for the 2nd joystick settings?

Navigation

[0] Message Index

[*] Previous page