| Main > Main Forum |
| Help with T-Molding inside corners |
| (1/3) > >> |
| AMDman13:
I decided to T-mold 360 around the entire machine. Everything went pretty well, however I can't get the t-molding to snug into the inside corner (where the CP backs into place). I cut the spine down pretty darn good too, but there is still a small gap in the very corner. Now my CP box does not set flush against the cab. >:( Anyone have any ideas on how to get this to lay flat? Anyway, glad to be done sanding and paiting. Thanks |
| leapinlew:
A picture please! Otherwise - I suggest beating the hell out of it. Or some glue plus beating the crap out of it. |
| ahofle:
If the CP is backing into it will you even see it? I'd make a cut right in the corners if that's the case. |
| AMDman13:
--- Quote ---A picture please! --- End quote --- I would, but I leant the dang digital camera to my mother and she's in VA for a month! --- Quote ---If the CP is backing into it will you even see it --- End quote --- Ahh! Me! :D I know I would not be happy with it unless it's perfect. That's just the way I am. Thats why I must have sanded and repainted untill I was blue in the face. Cutting it was the first thing I thought of and almost did it, but something told me to ask first. I find it hard to bang it since it is the inside bend (can't get to it with a mallet. |
| Fozzy The Bear:
--- Quote from: marlborroman13 on August 09, 2006, 07:31:32 pm ---Cutting it was the first thing I thought of and almost did it, but something told me to ask first. I find it hard to bang it since it is the inside bend (can't get to it with a mallet. --- End quote --- First thing to note is that with T-Molding, all inside and outside corners should have a radius to them and not be a very sharp corner. If they're a very sharp corner then it's always best to cut to the corner and start again from there with the next section. If you do have a radius to the corner....Put hot melt glue in the routed slot... stick a broom handle into the corner, against the T-Molding, and bang the hell out of the broom handle with a big hammer or rubber mallet. Always works for me. Best Regards, Julian (Fozzy The Bear) |
| Navigation |
| Message Index |
| Next page |