| Main > Main Forum |
| Moniter is here, Arcade VGA over there, and a bunch of chopped wires in middle. |
| (1/2) > >> |
| rackoon:
OK I got a 27" dotronix monitor from GGG and it has a 9pin VGA hook up. I got a Arcade VGA card from Ultimarc with a 15pin VGA hook up. I got a 15pin VGA cable cut and stripped. Got a Radio Shack 9pin connector plug end. Got a multi meter with a crap load of dial settings on it. So help me out. I guess I'm looking for continuity from wire to pin with multi meter. I get the part about red thingy on one side and black thingy on other but what about all these settings on the dial? Am I on the right track? :banghead: |
| krick:
This might help.... http://www.interfacebus.com/Design_VGA_PinOuts.html |
| grantspain:
:laugh2: :laugh2:,sorry but this is funny-if you want to meter continuity in cables its best to use either ohms setting or better if you have a bleep test(gets your leads in correct black always to common and the red should go to volts ac/dc,ohms not amps)-once again sorry to laugh :laugh2: |
| rackoon:
I don't get whats so funny. I don't know what I'm doing. I'm not sure continuity is even what I'm looking for. :tool: |
| rackoon:
Ok let me just ask this: How do I figure out witch pin goes to what wire? :lame: |
| Navigation |
| Message Index |
| Next page |