| Main > Main Forum |
| After a special type of T-Mold?? |
| (1/1) |
| lettuce:
Does anybody know of a type of T-Mold that has lips at the top and bottom, so it would clamp plexi glass to a CP base?? I have a 1/2" MDF CP base and a sheet of plexi-glass covering it, and would like to clamp these together. As i think that the 1/2" MDF would be too narrow to route for normal T-mold?? |
| NightGod:
1) there is 1/2" T-molding 2) T-molding with lip |
| lettuce:
The t-mold with lip is 13/16'' that would be to wide for 1/2" plus plexi-glass would it not? |
| Stingray:
--- Quote from: lettuce on August 05, 2006, 10:11:02 am ---The t-mold with lip is 13/16'' that would be to wide for 1/2" plus plexi-glass would it not? --- End quote --- Plexi comes in more than one thickness y'know. ;D -S |
| Fozzy The Bear:
--- Quote from: lettuce on August 05, 2006, 10:11:02 am ---The t-mold with lip is 13/16'' that would be to wide for 1/2" plus plexi-glass would it not? --- End quote --- Yes but as has been said it depends how heavy your plexi is.... Plus you could always add a shim of plywood to the bottom of your 1/2" MDF around the outside edge, where you are putting the T-molding. Best Regards, Julian (Fozzy The Bear) |
| Navigation |
| Message Index |