The vinyl from Happs is self adhesive. Easy to work with. Here is some info I received on installing it. Good Luck.
Here are some application pointers.
:)The vinyl has a self adhesive backing to it. You just peel off the backing and apply it.
;)To apply it, you will first need to remove the t-molding from your cabinet. Removing the t-molding will allow you to trim the excess vinyl off using a razor blade. Make sure the cabinet is stripped of all it's original vinyl.
:DThe new vinyl will probably not want to stick to old vinyl. Once all the old vinyl is removed, you will also have to remove any glue that was left behind. Sanding it usually works. It is a painstaking process, but if the wood is not totally smooth, the vinyl may not stick properly.
:-*Now, for applying it... you will definitely need two people to apply the vinyl on the sides of the cabinet. (the pieces are just too large for a single person to handle). To apply it, you will have to lay the cabinet down on it's side. Do not try to line up the edge of the vinyl with the edge of the cabinet to save yourself from having to trim a side. Just let the vinyl cover over all sides of the cabinet and trim the excess off.
;DAlso, do not try to apply the entire piece at once. Just start at one end of the cabinet and work your way across to the other end. I usually have someone holding the one end of the vinyl up while I work at the other end. I just peal back about a foot of the backing and apply it to the one end of the game, letting about 2 or 3 inches hang over. I rub it down with a soft cloth or plastic straight edge, making sure to get any air out from underneath.
:oOnce that section is down, I have the person holding the other end lower it down a little and then I peal back a little more of the backing and rub that section down. I just keep doing this until I get to the other end of the cabinet.