| Main > Main Forum |
| What's this crazy Tekken 2 wiring? |
| << < (2/2) |
| Kevin Mullins:
Well.. you kinda throw me off a bit every time I see you use the term "cartridge".... I hope we're talking about the same thing. This is a typical Tekken 2 "PCB". (Printed Circuit Board) http://www.crazykong.com/pcbs/T%20-%20Z/Tekken2.pcb.html Aside from that... I wouldn't expect them to change the wiring setup just because of a minor revision to the program if there are any. Trace your wiring from the player controls TO the harness connector and see if they match the pinout I found. Then go from there, whether or not to move them to the standard JAMMA connector so the JPAC will interface with them. |
| MartyNg:
--- Quote from: Kevin Mullins on July 30, 2006, 08:35:55 pm ---Well.. you kinda throw me off a bit every time I see you use the term "cartridge".... I hope we're talking about the same thing. This is a typical Tekken 2 "PCB". (Printed Circuit Board) http://www.crazykong.com/pcbs/T%20-%20Z/Tekken2.pcb.html Aside from that... I wouldn't expect them to change the wiring setup just because of a minor revision to the program if there are any. Trace your wiring from the player controls TO the harness connector and see if they match the pinout I found. Then go from there, whether or not to move them to the standard JAMMA connector so the JPAC will interface with them. --- End quote --- Yes, by "cartridge" I mean the PCB. (I'm a console gamer at heart) ;) Hopefully I will have a chance to go through all the wiring in the next couple of weeks. By re-wiring those few buttons, I will be effectively breaking my Tekken 2 capability, but will be able to play other JAMMA games that are more standardized in the contorl scheme. Is this a correct statement? |
| MartyNg:
--- Quote from: MartyNg on July 29, 2006, 02:45:51 pm ---Through the JPAC test software: P1 Start, P1B1 and P1B2 all register normally. P1B3 and P1B4 do NOT register (--BINGO! Either that, or I was attempting to say "before" but it was too many letters to type-- wouldn't go through JAMMA anyway, of course) HOWEVER, when I hit P1B3 + P1B4 TOGETHER, it registers on the JPAC as P1B3! How can this be if neither register through the JAMMA harness? P2 Start registers. No other player 2 controls register. --- End quote --- I spoke with Andy at Ultimarc and he informed me that a chip on the JPAC was defective. So if any of you see similar problems, give him a holler! |
| Navigation |
| Message Index |
| Previous page |