| Main > Main Forum |
| General joystick mounting question |
| << < (3/4) > >> |
| brophog:
1 1/8" works well for most joysticks and all Happs buttons. |
| zerocle:
yeah thats what i figured, why would happ require you to buy two different size drill bits, and i got my 5/8 " at Lowes, its like a scottsdale home depot, at least thats the way i look at it, they are a little more expensive, but they had what I was looking for. |
| ahofle:
I could swear I had issues with the shaft touching the wood with 1 1/8" holes but it sounds like it works fine too. Sorry for the misinformation. :-[ |
| zerocle:
maybe its because yours is so deep? |
| ahofle:
That could be as well. I didn't route out any wood and there is a 1/8" piece of lexan in addition to the 5/8" MDF, so 3/4" total thickness the joystick shaft needs to clear. Either way, use scrap wood to test everything out before cutting the real CP. :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |