Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Bezel install/size question.  (Read 991 times)

0 Members and 1 Guest are viewing this topic.

442much

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 52
  • Last login:May 23, 2008, 09:27:36 pm
  • I want to build my own arcade controls!
Bezel install/size question.
« on: July 19, 2006, 10:43:09 pm »
I have a 27" Betson monitor with the flat screen, so I purchased the flat flat 27" bezel from Happs.  The problem that I'm having is with the size of the bezel.  The bezel is only 25 3/4" wide x 24 1/4" high.  My cab is 26" wide x 24 3/4" high.  I was under the impression that these bezels were oversized and needed to be trimmed to fit. 

Does anybody have any suggestions on how to make this look good?


Logged
Pages: [1]
  
Go Up
« previous next »