Main > Main Forum
best way to cut t-molding...?
(1/2) > >>
fixedpigs:
what is the best way to get a straight cut on the end of t-molding...?

                                                                                     thanks...!
Circo:
I just used a utility knife, had no problems whatsoever.
javeryh:
I used a utility knife too and it came out fine (not 100% perfect but close enough).  There is a thread around here somewhere where someone used a pipe cutter to get the perfect cut...
leapinlew:
I used scissors.
somunny:
I have one of those cutters that places like Home Depot use to cut rubber/plastic tubing.  Perfect cut every time.

Steve
Navigation
Message Index
Next page

Go to full version