Main > Main Forum

Quick Question on build but late

Pages: << < (3/3)

amerish:

I have built 2 UA IIs (why build one at full price when you can build two at twice the cost).

My previous answer was based upon the same concerns about the MDF shelf failing because the screws might not be centered.

I added a small strip of wood about 6 inches wide from the front of the cab to the back, glue and screws (screwed from the inside so no holes on the outside). Then I installed the shelf with more glue and then screwed down onto my supports. Very strong, no problems.

If you are concerned about deflection of the shelf from weight, add a center support under the shelf (think of supports for your flooring). There is plenty of room in the UA IIs for it.

I also installed a raised strip of wood (an inch or two proud of the shelf surface) across the back of the shelf as an added safety precaution to ensure that the TV I was using would not slide off the back.

Finally I added some mesh fabric grips stapled to the shelf (used for kitchen dishes to keep dishes from sliding). The result is that the TV does not slide back.


Pages: << < (3/3)

Go to full version