Main > Main Forum

GP-Wiz49 wiring??

Pages: (1/2) > >>

lettuce:

I have a GP-Wiz49 interface No-Solder version, and am a bit unsure where to wire the left over wires from the IDE cable that dont plug into the 49-way joystick. Where do these extra strip of wires on the IDE cable go to?

RandyT:


--- Quote from: lettuce on May 30, 2006, 01:04:17 pm ---I have a GP-Wiz49 interface No-Solder version, and am a bit unsure where to wire the left over wires from the IDE cable that dont plug into the 49-way joystick. Where do these extra strip of wires on the IDE cable go to?

--- End quote ---

They go to buttons, etc.  But you may want to use a "euro" style terminal block in-between.  You can also wire them directly to your button wires.

Check out the diagram on the instruction sheet.  It will tell you which pin does what.

RandyT

lettuce:

How many buttons can you wire to the GP-Wiz49?

Timoe:

23 or more.

So you can wire a regular Happ Competition stick (or 2) plus all your buttons to the GPwiz in addition to the 49 way stick if you want. 



I plan to use a GPwiz49 to power an entire control panel (minus the trackball and spinner of course)

lettuce:

Ah, i think i have the GP-Wiz49 Eco version, that doesnt support than many buttons does it?

Pages: (1/2) > >>

Go to full version