| Main > Main Forum |
| GP-Wiz49 wiring?? |
| (1/2) > >> |
| lettuce:
I have a GP-Wiz49 interface No-Solder version, and am a bit unsure where to wire the left over wires from the IDE cable that dont plug into the 49-way joystick. Where do these extra strip of wires on the IDE cable go to? |
| RandyT:
--- Quote from: lettuce on May 30, 2006, 01:04:17 pm ---I have a GP-Wiz49 interface No-Solder version, and am a bit unsure where to wire the left over wires from the IDE cable that dont plug into the 49-way joystick. Where do these extra strip of wires on the IDE cable go to? --- End quote --- They go to buttons, etc. But you may want to use a "euro" style terminal block in-between. You can also wire them directly to your button wires. Check out the diagram on the instruction sheet. It will tell you which pin does what. RandyT |
| lettuce:
How many buttons can you wire to the GP-Wiz49? |
| Timoe:
23 or more. So you can wire a regular Happ Competition stick (or 2) plus all your buttons to the GPwiz in addition to the 49 way stick if you want. I plan to use a GPwiz49 to power an entire control panel (minus the trackball and spinner of course) |
| lettuce:
Ah, i think i have the GP-Wiz49 Eco version, that doesnt support than many buttons does it? |
| Navigation |
| Message Index |
| Next page |