Main > Main Forum
Way to tell if a cab's power supply is good/bad?
payment_due:
I've got a cab that I bought from a guy that is a MAME machine, so obviously I don't use the internal supply for PCBs.
Does anyone know of a way to see if it still works, other than plugging in a PCB? I have none at the moment, and I'm a bit leery about asking my friends to borrow one of theirs because I wouldn't want to ruin it if the PS I have is bad.
The guy said he never used the PS because he bought the cab sans PCB and turned it into a MAME cab immediately. He said he assumes it works, but is not 100% sure.
Any help would make me do this: :notworthy:
Thenasty:
use a voltmeter ;D
payment_due:
Thanks, what kind of power reading am I looking for though? I know how to use a volt-meter, but I'm no electronics expert by any means.
SirPeale:
If it's a standard AC --> DC power supply, like a Peter Chou, the voltages will be marked on the tabs. A PS can 'read' good, but if you touch the voltage adjustment pot, it may shut down.
Best way to test a PS is under load. If you value your board, I wouldn't use it, though! Find another way (like a heavy ceramic wire-wound resistor) to put it under load.
If it doesn't have the screw tabs, but has a molex wiring connector, standard wiring colors usually apply: black for ground, red for +5V, yellow for +12V.
payment_due:
--- Quote from: Peale on May 14, 2006, 12:09:19 pm ---If it's a standard AC --> DC power supply, like a Peter Chou, the voltages will be marked on the tabs. A PS can 'read' good, but if you touch the voltage adjustment pot, it may shut down.
Best way to test a PS is under load. If you value your board, I wouldn't use it, though! Find another way (like a heavy ceramic wire-wound resistor) to put it under load.
If it doesn't have the screw tabs, but has a molex wiring connector, standard wiring colors usually apply: black for ground, red for +5V, yellow for +12V.
--- End quote ---
Thanks Peale. I'll need to get my buddy who is studying to be an EE to help me out then. I'm pretty sure the PS is fine, but I don't want to risk ruining a friends PCB, or mine when/if I get one.