Main > Main Forum
MOD: Suzo Universal Inductive
kowal:
I have only red balltop sanwa.
price 12-14USD (pivot, red balltop sanwa LB35, stick stainless steel + ferrite ring)
if it would be buyers more (<8-10) I would can order different colours.
Level42:
Well.......I might change my mind on these.....if only for the fact how much I appreceate Kowals initiative and work !
I can hear the requests for hollow shafts, white transparant balls and LED lighting coming right up :D
P.S. I only now noticed how you connected your wiring to the connector, very nice ! I had an occasional problem with wires getting out of the original connector. I actualy already have these metal pins and even probably a right connector that fits from my work ! Will give it a try tomorrow ! Thanks Kowal
Grasshopper:
I'm not too bothered about the ball tops as they are sold in a variety of colours (including translucent) by another board member (ponyboy).
So what would be the price for just the pivot, stainless steel stick and the ferrite ring?
Thanks
kowal:
Grasshopper:
pivot, stainless steel stick and the ferrite ring - price 9 USD (without ball!)
I will execute handles 3-4 weeks. I have to know only quantity buyers.
I have to buy material. Not much persons have this joystick. I will make only one limited series.
--- Quote ---I can hear the requests for hollow shafts, white transparant balls and LED lighting coming right up
--- End quote ---
this would be possible but this is difficult. I can buy from stainless steel tubes. But problem will be from installing ball ???
the thread of a screw M6 will be to make problm. To make different thread of a screw (M9) in ball completely and place on led.
Yes defult conektor sucks :P I use PH 2.54
on Sanwa JLF looks so:
Level42:
Hi Kowal,
OK, I'm convinced, put me down for two complete sets (so including the ball, if you change your mind and will offer other colors then solid red, let me know ! I totaly love this one: Sanwa LB-35-MP ()
About the hollow shaft: I know nothing of metal working, I only mentioned this because I've seen the other ball top handles with leds. I don't really need them, but they would rock of course ;) For now I'm happy with what you will offer.
I've now fitted one of my Inductives with the connectors from my work, GREAT ! I only had 2, 4 and 10 pin connectors, so I used one 4 pin and one 2 pin connector. Had to cut off the "lips" on these connectors, now they fit perfectly and are very sturdy. This is much more reliable then the original "push-in" connectors. This will also be great for my Suzo Trackball, because this uses the same connectors.