| Main > Main Forum |
| MOD: Suzo Universal Inductive |
| << < (6/22) > >> |
| kowal:
I have only red balltop sanwa. price 12-14USD (pivot, red balltop sanwa LB35, stick stainless steel + ferrite ring) if it would be buyers more (<8-10) I would can order different colours. |
| Level42:
Well.......I might change my mind on these.....if only for the fact how much I appreceate Kowals initiative and work ! I can hear the requests for hollow shafts, white transparant balls and LED lighting coming right up :D P.S. I only now noticed how you connected your wiring to the connector, very nice ! I had an occasional problem with wires getting out of the original connector. I actualy already have these metal pins and even probably a right connector that fits from my work ! Will give it a try tomorrow ! Thanks Kowal |
| Grasshopper:
I'm not too bothered about the ball tops as they are sold in a variety of colours (including translucent) by another board member (ponyboy). So what would be the price for just the pivot, stainless steel stick and the ferrite ring? Thanks |
| kowal:
Grasshopper: pivot, stainless steel stick and the ferrite ring - price 9 USD (without ball!) I will execute handles 3-4 weeks. I have to know only quantity buyers. I have to buy material. Not much persons have this joystick. I will make only one limited series. --- Quote ---I can hear the requests for hollow shafts, white transparant balls and LED lighting coming right up --- End quote --- this would be possible but this is difficult. I can buy from stainless steel tubes. But problem will be from installing ball ??? the thread of a screw M6 will be to make problm. To make different thread of a screw (M9) in ball completely and place on led. Yes defult conektor sucks :P I use PH 2.54 on Sanwa JLF looks so: |
| Level42:
Hi Kowal, OK, I'm convinced, put me down for two complete sets (so including the ball, if you change your mind and will offer other colors then solid red, let me know ! I totaly love this one: Sanwa LB-35-MP () About the hollow shaft: I know nothing of metal working, I only mentioned this because I've seen the other ball top handles with leds. I don't really need them, but they would rock of course ;) For now I'm happy with what you will offer. I've now fitted one of my Inductives with the connectors from my work, GREAT ! I only had 2, 4 and 10 pin connectors, so I used one 4 pin and one 2 pin connector. Had to cut off the "lips" on these connectors, now they fit perfectly and are very sturdy. This is much more reliable then the original "push-in" connectors. This will also be great for my Suzo Trackball, because this uses the same connectors. |
| Navigation |
| Message Index |
| Next page |
| Previous page |