| Main > Main Forum |
| How should I overlay this CP? |
| << < (2/3) > >> |
| leapinlew:
Am I crazy to think that t-molding notched properly would wrap around that point? |
| ahofle:
My guess is it would not retain the sharp point and would round out a tad, but it would stay put if properly notched. Then again, the slight roundedness might a good thing for peoples' nuts and bellies. ;D You could also cut the t-molding right where the points are (which would leave a seam, but might look better anyway). If it were me, I would first try what leapinlew suggested and if it doesn't work, then cut it there. |
| Q*Bert_OP:
Oh no!!!! :hissy: A Pac man with a Frankenpannel!!! :laugh2: |
| wrench:
a flush cut router bit will cut through the lexan like butter,you may need to clean up the 2 inside corners with a file.Ditto on the t molding.I think if notched correctly it will wrap around the corners fine. |
| wrench:
another option instead of t-molding is shown on the link below which worked nicely for me but it would take a lot of patience notching those 2 corners. http://forum.arcadecontrols.com/index.php?topic=46432.msg444429#msg444429 |
| Navigation |
| Message Index |
| Next page |
| Previous page |