Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: anyone ever use an rj45 switchbox as an arcade monitor switch?  (Read 1560 times)

0 Members and 1 Guest are viewing this topic.

davieboynj

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 269
  • Last login:June 16, 2011, 01:32:09 am
  • Eating your legs solves lifes little problems.
anyone ever use an rj45 switchbox as an arcade monitor switch?
« on: May 04, 2006, 01:07:56 pm »
I was planning on picking up one of these:
http://www.computercasesandcables.com/ccc/105-0060
and wiring R, G, B, Sync, Ground, and Controller Ground through the switch to the monitor/CP.
I don't really care if i have two games running at the same time, i don't want to run power through it, unless i do it through a relay.  I have a sneaky suspicion that the switch would burn out if i sent that power through it. 

Has anyone tried this?  I'm a little too cheap for multijamma, especially in a dedicated arkanoid cabinet..  :)
Logged
Pages: [1]
  
Go Up
« previous next »