| Main > Main Forum |
| cutting MDF which is better router or circular saw |
| (1/4) > >> |
| kiddk1:
i am cutting out my CP and needed advice on what to use on the mdf for cutting it. |
| miles2912:
Saw board and circular saw. Not as messy and will make a clean straight line. The only time you would want to route MDF is when you are using a pattern bit to make a copy of one side. Don |
| babydickonboard:
another vote for circular saw + jig. |
| Tahnok:
A circular saw is better, if you also have a jig saw to make curves. If you are only looking to buy a single tool, a router is more versatile. |
| cnlmoore:
Circular saw is good as long as the panel is fairly large. Cutting smaller pieces of MDF with a circular saw can be dangerous if not done properly. Table saw would be the best bet. MDF + router = a ton of dust. You would have to make multiple passes to cut clean through. OK to use for a joystick or trackball cutout as it does provide nice clean edges. Good luck. |
| Navigation |
| Message Index |
| Next page |