Main > Main Forum

Sanwa Joystick Wiring...

Pages: (1/2) > >>

TalkingOctopus:

I just received some Sanwa parts from Ponyboy.  The joystick has 5 pins for wires.  However, I don't know what each pin goes with.  What's ground, what's down ect...

I searched around for this, but found no answers.  I could take it apart and trace it, but I'd figure I'd ask here first.  Does anyone know what pin goes with what?





Thanks!

Orclord:

Just dug the Multi out....

2nd picture..... from  left to right

Gnd.....Up....Down.....Left.....Right

That's what it looks like on mine....

TalkingOctopus:


--- Quote from: Orclord on May 02, 2006, 04:59:30 pm ---Just dug the Multi out....

2nd picture..... from  left to right

Gnd.....Up....Down.....Left.....Right

That's what it looks like on mine....

--- End quote ---

Excellent.  Thanks!

kiddk1:

if you wouldnt mind helping me out too.  Also what is the yellow piece for?  I have the 5 prong wire just dont know which wire goes where on my keywiz

StuckInJapan:

kiddk1, that yellow piece is a restrictor plate used exclusively on Seimitsu sticks - if someone sold this to you as a Sanwa, you've been lied to.
The plate "restricts" the actual movement of the shaft:
using the top circular hole will make it an 8-way, the middle groove will
only allow 2-way movement, and the diamond shape at the bottom will make it a 4-way by making diagonals impossible.
Sanwas and Seimitsus use the same pin-out and are interchangeable,
so Orclord's post should apply to you as well.


Pages: (1/2) > >>

Go to full version