Main > Main Forum
SPECIAL ANNOUNCEMENT ON WICO BALLTOP JOYSTICK HANDLES
miles2912:
Just to clear this up. The Perfect 360 stock handle is 6" overall. Are the Wico handles measured differently or are they just a shorter throw? My 360's are mounted so the handle is right where I want it and if I make a switch I need to know if I have to re-mount them.
Thanks
Don
RobotronNut:
the wico ball-top handles are not the same length as the stock p360 bat top.
i don't have measurements for the stock bat-top handy, but i do have measurements for the wico ball-tops. you'll have to measure your bat top, with whatever spacers you have installed, and then compare to the following measurements, which are all from the top of the joystick base to the top of the ball:
4" wico + p360 "wood" spacer - 3 1/8"
4" wico + p360 "metal" spacer - 2 3/4"
4" wico (no spacer) - 2 5/8"
3.5" wico - 2 1/2"
these measurements are somewhat rough; i just measured by eye with a ruler, with no precise parallax correction.
i'm pretty sure the last two measurements (4" wico with no spacer and 3.5" wico) are actually identical, even though the numbers i listed differ by 1/8". i measured them at different times and never went back and compared them to each other directly.
miles2912:
The bat top wth 'wood' spacer the stick extends out from the base is 3 5/8". So a ball top would drop it about a half inch. OK, good to know.
Don
ponyboy:
BUMP!!!
Luckydevil:
For more info on the measurements and how they take to dying...
look for the thread "Wico Balltop and P360 Shaft side by side"