| Main > Main Forum |
| (staining)now in need of router help |
| << < (2/2) |
| ShinAce:
Now I have a new question, regarding putting a 45 degree mitre on the panels I've cut. I don't have a router, but can borrow one easily. However, I imagine a table router is going to be the way to go. I've cut the panels, squared them up, and sanded the edges. I'm thinking there will be no way to get a perfectly straight mitre on all edges unless I use a table router. At least that way, once routed, all panels will have exactly the same dimensions. Is this correct? |
| Fozzy The Bear:
Yes... you could table route the edges..... But an easier option if you have one, is to cut it using a table circular saw. Pretty much the same result really. Best Regards, Julian (Fozzy The Bear) |
| ShinAce:
Hmm, very true.... |
| Navigation |
| Message Index |
| Previous page |