| Main > Main Forum |
| Alternative to soldering Happ buttons/sticks to PSX controllers? |
| << < (3/4) > >> |
| eastbayarb:
JonnyBoy, X-Arcade encoders are out of the question because I plan on using 4 PSX pads for my 4-player control panel. Everyone else, thanks for the advice! Oh, does anyone know of a tutorial for properly soldering arcade joysticks/buttons to a dual shock controller? I plan on using these pads on console systems/games that require analog controls. |
| eastbayarb:
Thanx for all the help guys! I wired up a PSX pad to my CP and Happ buttons and sticks and though it took about a couple of hours, it works GREAT!. |
| EwJ:
great! if you're still looking for soldering tutorial and playstion controller hack info or for others looking this up in the future, there's some info right here: http://arcadecontrols.com on the left hand side under 'tech & tips' then under 'step-by-step guides' and 'tutorials', |
| eastbayarb:
Now I am actually thinking of doing some dual shock psx pads but no tutorial I know of exists... also, does anyone know if P360 joysticks will work with a PSX pad? |
| pmc:
--- Quote from: EwJ on April 29, 2006, 12:18:59 am ---i'll second that haneylp - tinning the wires helps -and cleaning and re-tinning the tip of the soldering iron too. --- End quote --- What's the best way to clean the tip? Mine is all fugly from years of use. I used to use a wet paper towel or sponge while it was hot, but it no longer comes clean. I probably need to replace the tip anyway. -pmc |
| Navigation |
| Message Index |
| Next page |
| Previous page |