Main > Main Forum

Using a metal hole saw on aluminum

Pages: << < (3/3)

quarterback:


--- Quote from: mccoy178 on April 20, 2006, 10:04:37 pm ---I just made a little tutorial on how I made my holes.  They were a hair too small for the leaf switches.

--- End quote ---

Exactly!  In your previous search you must not have found my "Battle Royale Thread" where the masses kept trying to convince me that my leafs were going to fit into 1-1/8" holes even though it was clear they were not.

For those who are interested, you can start with this post and read the back and forth..  I finally had to contact Knievel via a PM and beg him to post in my thread since people didn't seem to believe me that it takes a 1-3/16" hole for leaf buttons to be installed in a metal CP, not 1-1/8"

Pages: << < (3/3)

Go to full version