Front End Support > MaLa Frontend
MaLa v1.0 RC1 available
Aceldamor:
Would I be correct in assuming that the hardware for the LED controller is 113 dollars US?
swindus:
At the current dollar rate:
LCD/16LED Assembly
Circuit board with controller, 16 high output Leds, 16 resistors, all needed cables (Led, LCD and USB)
75 USD
LCD/16LED Ready to go
Circuit board with controller, 16 high output Leds, 16 resistors, all needed cables (Led, LCD und USB), completely assembled
100 USD
32LED Assembly
Circuit board with controller, 32 high output Leds, 32 resistors, all needed cables (Led and USB)
88 USD
32LED Ready to go
Circuit with controller, 32 high output Leds, 32 resistors, all needed cables (Led and USB), completely assembled
113 USD
Plus full software support with MaLa.
loadman:
--- Quote ---32LED Assembly
Circuit board with controller, 32 high output Leds, 32 resistors, all needed cables (Led and USB)
88 USD
--- End quote ---
A Led wiz may be cheaper but it does not include required Leds, resistors, ALL required cables or current FE support.
So keep that in mind if you are shopping for some added 'bling' for your cab
:D
RandyT:
--- Quote from: loadman on April 30, 2006, 06:08:04 am ---
--- Quote ---32LED Assembly
Circuit board with controller, 32 high output Leds, 32 resistors, all needed cables (Led and USB)
88 USD
--- End quote ---
A Led wiz may be cheaper but it does not include required Leds, resistors, ALL required cables or current FE support.
So keep that in mind if you are shopping for some added 'bling' for your cab
:D
--- End quote ---
The LED-Wiz can be used with some of the most popular current FE's and there is even a version of MAME that supports it directly. As for the wiring, the LED-Wiz supports driving up to 25 ultra bright LED's per output, full RGB control (110592 possible colors), 48 levels of intensity per output, hardware modulation FX , etc. It is often used in these different configurations, making pre-made harnesses mostly unsuitable for the majority of users.
Please make sure your claims are, at least, accurate.
Thank you.
RandyT
swindus:
So what does it cost to drive 25 ultra bright LED's per output or 32 rgb LED's?
No offense, I just want to know.
BTW, if it isn't considered bad taste to post about your product in a competitors thread, it should be. ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version