| Main > Main Forum |
| What tool(s) do you use for drilling button holes? |
| (1/4) > >> |
| eastbayarb:
I did a search on this but not much of a deffinite answer. I am trying to add buttons to my control panel (I did not make this control panel but I am modifying it) but i need advice on what tool(s) to use for drilling proper sized holes for the buttons. Thanx |
| ArcadEd:
1 1/8th inch Hole Saw, Paddle Bit or Forsner (sp?) bit |
| eastbayarb:
you got pictures of this "1 1/8th inch Hole Saw, Paddle Bit or Forsner (sp?) bit" thanks for the advice |
| ArcadEd:
Paddle Bit Hole Saw Forstner Price wise, the paddle bit is the cheapest, then hole saw, then forstner Good luck |
| Tahnok:
You'll have better luck finding a 'paddle bit' if you search for it as a spade bit. Some will argue the spade bit will give you rougher holes than the others. They all do a good enough job though for most CPs though. |
| Navigation |
| Message Index |
| Next page |