| Main > Main Forum |
| Groovygamegear Spinner Question **SOLVED** |
| (1/1) |
| oldskoolcade:
Just got my spinner (yay Randy!) Maybe I'm dumb (my wife seems to think so most times), but I can't figure out how to adjust the height of the shaft so I can make it fit my control panel. On the site it says to loosen the set screw, but I don't know which that is or where. Anybody with some info that could help a dumb guy out, would be appreciated! Cheers! Mike |
| Timoe:
here ya go! you will need a small allen wrench to loosen this screw. Then pull the shaft up to the height you need and retighten the set screw. Be sure not to over tighten. |
| oldskoolcade:
Thanks dude! The second I saw your post, I got an e-mail from Randy explaining the same thing :D As I said to him, I knew it was a simple solution...it's just that I'm a little slow today :P Cheers! Mike |
| Navigation |
| Message Index |