| Main > Main Forum |
| anybody know where to get 135 degree L metal bracket? |
| (1/2) > >> |
| bossyman15:
i tried unbending 90 degree bracket but it didn't turn out good. i would need 135 degree but no one sells it. know anyone who sells it or can anyone give me the tips on how to unbend it? |
| Tahnok:
How strong does it need to be? Personally, I make 135 degree brackets out of plumbers' tape. |
| bossyman15:
oh Aluminum around 1/8" thick and it would be need to have 3/4 width on one side and 3/4" or less (but not too small for drilling and screwing) on other side. |
| whammoed:
Get some aluminum flat bar and stick it in a vise. Hammer it until it bends to the correct degree. Sounds crude but it works pretty well actually. |
| bossyman15:
But I don't have vise |
| Navigation |
| Message Index |
| Next page |