Main > Main Forum

Trick for this darn e-clip on the P360?

Pages: << < (3/4) > >>

rdagger:


--- Quote from: dpz147 on March 29, 2006, 03:26:35 pm ---That seems to be for the Wico stick...mine is the one that came with the 360.

But, if I had to cut it, what is the best thing to cut it with?

--- End quote ---

I think Wico and Happ buy from the same manufacturer.   
The Happ instructions also state that the sleeve (bushing) should be 1/2" for wood.

I cut mine carefully with a small hack saw.  You don't want to cut it too short. 


whammoed:


--- Quote from: rdagger on March 29, 2006, 04:48:30 pm ---
--- Quote from: dpz147 on March 29, 2006, 03:26:35 pm ---That seems to be for the Wico stick...mine is the one that came with the 360.

But, if I had to cut it, what is the best thing to cut it with?

--- End quote ---

I think Wico and Happ buy from the same manufacturer.   
The Happ instructions also state that the sleeve (bushing) should be 1/2" for wood.

I cut mine carefully with a small hack saw.  You don't want to cut it too short. 


--- End quote ---
rdagger, isn't it supposed to come with both sized bushings and you just use the one you need for your panel?  If not, it really stinks if you have to cut it to size.

dpz147:

I haven't measured it but I'm assuming the one they sent me is .5".

I've read some previous posts from a year or two ago where it was common to be sent 5/8" by accident.  Maybe that's what happend to you. 

I'll measure it when I get home.

rdagger:

I bought 4 and they all came with sleeves that were just over 5/8".
If your sleeve is already 1/2" then you probably just need to compress the springs a little to make it fit.


hypernova:


--- Quote ---isn't it supposed to come with both sized bushings and you just use the one you need for your panel?
--- End quote ---

Yes, they are.  You use one or the other.  And if you use a slikstik replacement handle, you shouldn't use either of them.

Pages: << < (3/4) > >>

Go to full version