| Main > Main Forum |
| Trick for this darn e-clip on the P360? |
| (1/4) > >> |
| dpz147:
OK...I give up! How do you get this :censored: e-clip on the P360? After all the hardware is on, there no room for it. I tried pushing down on the joystick, but there didn't seem to be any give. Any tricks from the pros around here? Thanks in advance for any help! |
| Havok:
I use a larger set of pliers, opened up slightly to press down on two sides of the insert, and then with my other hand, use a set of needle nose pliers to place the e-clip into the groove. |
| dpz147:
Just to clarify...by "insert" you mean the actuator? |
| hypernova:
Yes. You push on the underside. |
| RayB:
push the plastic sleeve down against the spring, so the groove becomes accessible. |
| Navigation |
| Message Index |
| Next page |