| Main > Main Forum |
| need happ P360 measure. |
| << < (4/5) > >> |
| bossyman15:
--- Quote from: Fozzy The Bear on March 25, 2006, 01:01:32 pm --- This is the P360 mounting, actual size.... Print it at 72dpi... and yes it is the right way round. Best Regards, Julian (Fozzy The Bear) --- End quote --- how do i print it at 72dpi?... what program do i use? |
| bossyman15:
oh never mind i got it i loaded it up in visio and got it. it printed out as 3 9/16" x 3 1/8" is that right? |
| rwhip41:
I already supplied the measurements above from my 360. I used my micrometers, which are accurate to 0.001". Based on those measurements and those supplied by others, I would rely on 3.5" x 3". |
| Havok:
--- Quote from: Fozzy The Bear on March 25, 2006, 02:59:19 pm --- --- Quote from: RichyRich on March 25, 2006, 02:41:51 pm ---Hey fozzy, are you sure thats the right way round? if I pushed up on mine with your template it would activate right or left.Mines 90 degrees rotated??? --- End quote --- Interesting.... Mine in my first panel is that way round.... rwhip41 appears to have it that way round as well according to his measurements. Best Regards, Julian (Fozzy The Bear) --- End quote --- If you want the contacts to be correct (left is left, etc.) then you have to mount it "sideways" with the contacts to the right. You could mount it any way you want, just be aware you have to switch your connections to compensate... |
| RichyRich:
not true....if you undo the four screws on the base you can turn the sensors 90 degress to match up.It's really easy to do. |
| Navigation |
| Message Index |
| Next page |
| Previous page |