| Main > Main Forum |
| need happ P360 measure. |
| (1/5) > >> |
| bossyman15:
right now my CP is cut out for ulrimarc t-mag and one of hole (center of hole) is just under 3 inches from one of holes for trackball mount. see i might buy p360 sometime in the future when i have money so that's why i need measure of p360 so if i want to change joystick in the future it will fit in tight space. anybody? |
| KDOG:
I think all of the happs bases are the same. So if you can find either a super or comp measurement you should be strait. |
| RichyRich:
It will not fit,but you could always drill the hole pattern in the base of the 360. |
| bossyman15:
well you could just give me the measure of the base and i will cut it out on paper and see if it will fit. |
| Quarters:
The p360 base is a standard 3'' by 3.5'' same as most joysticks. There are some exceptions. The pattern from the happ ultimate will work fine.LINK |
| Navigation |
| Message Index |
| Next page |