Main > Main Forum
Is my Tornado Spinner missing a screw?
(1/2) > >>
Timstuff:
I got mine today and it works perfectly, however I was wondering... Is it supposed to include a screw to fasten the knob tightly to the shaft? Because mine only came with the four wood screws for moutning. Does anyone know size screw the knob takes?
whammoed:

--- Quote from: Timstuff on March 22, 2006, 03:17:02 pm ---I got mine today and it works perfectly, however I was wondering... Is it supposed to include a screw to fasten the knob tightly to the shaft? Because mine only came with the four wood screws for moutning. Does anyone know size screw the knob takes?

--- End quote ---

There should be two hex set screws (grub screws) in the knob already.  If they aren't there, I will figure out what thread they are so you can pick some up ( or have whoever sold it to you send them)
Timoe:
there should be a set screw (little tiny) that attaches the knob to the shaft

it should be on the knob itself
Timstuff:

--- Quote from: whammoed on March 22, 2006, 03:18:54 pm ---There should be two hex set screws (grub screws) in the knob already.  If they aren't there, I will figure out what thread they are so you can pick some up ( or have whoever sold it to you send them)

--- End quote ---

There were no scews included with the knob (which came wrapped seperately from the spinner). I bought it from SlikStik's website.
hypernova:
Sure?  There should be a very small black screw IN the knob.  Look on the side, around the circumference of it.  (I think there's only one, isn't there?)  It might be inset already, so you may not see it? 

edit:  I know it may sound like I'm being condescending, but I'm honestly not! :D
Navigation
Message Index
Next page

Go to full version