| Main > Software Forum |
| Mapping ZINC controls... |
| << < (2/6) > >> |
| deadsoulz:
Yeah , Read more carefully. Just use Aldos Front End to setup your config, then after that no need to use it anymore, they config will be saved, and you can use mamewah to launch zinc. |
| surf:
Thanks... Used Aldo's, works fine! http://www.aldostools.com/frontends.html |
| brophog:
That may be a rant, but it needs stickied in this board. |
| Congui:
Hi there. If what you want is to have the same key mappings as in mame, maybe this controller.znc will do the trick. Just rename from controller.txt to controller.znc and you're done. Hope this helps. Cheers, Congui |
| surf:
Well, now that I've installed Zinc in my cabinet, it loads up in MAMEWAH(!!!@) just fine, however.... After using Aldo's FE to set the controls, they only work for some games (I haven't tested them ALL)... but street fighter, xevious, tekken work, but mr driller doesn't?? What am I missing? Again, thanks for any help! All games load up fine and run, just the controls don't work right... |
| Navigation |
| Message Index |
| Next page |
| Previous page |