Main > Main Forum
New Product: Lightmite TB Trackball Lighting Module **They're Here...**
<< < (5/20) > >>
Fozzy The Bear:

--- Quote from: whammoed on March 18, 2006, 11:24:59 am ---Anyone with a 3" betson care to post a measurement...if they have a mounting hole pre drilled that is.

--- End quote ---

Yes they do have a mounting hole pre drilled.... In fact they have several mounting holes available on the bottom.

Nearest one to the ball is 16mm to the centre
Next nearest is a set of holes at 42mm to the centre.

Hope that helps!

Best Regards,
Julian (Fozzy The Bear)
whammoed:

--- Quote from: Fozzy The Bear on March 18, 2006, 03:51:07 pm ---
--- Quote from: whammoed on March 18, 2006, 11:24:59 am ---Anyone with a 3" betson care to post a measurement...if they have a mounting hole pre drilled that is.

--- End quote ---

Yes they do have a mounting hole pre drilled.... In fact they have several mounting holes available on the bottom.

Nearest one to the ball is 16mm to the centre
Next nearest is a set of holes at 42mm to the centre.

Hope that helps!

Best Regards,
Julian (Fozzy The Bear)

--- End quote ---

Yep.  Thanks.  Looks like the range for the current design with a Happ pcb mounting foot is anywhere from 13mm to 35mm so that 16mm hole would work fine.

Am I missing any others out there?
Kremmit:
I've got a Wico 3" TB with mounting holes 1.5" from the center of the lighting hole, 1 5/8" from center, and 1/2" from center.
whammoed:

--- Quote from: Kremmit on March 18, 2006, 10:11:59 pm ---I've got a Wico 3" TB with mounting holes 1.5" from the center of the lighting hole, 1 5/8" from center, and 1/2" from center.

--- End quote ---
Thanks Kremmit.  The 1/2" hole would be cutting it close and the 1.5" would be slightly out of range.  I think I will add an additional mounting hole on the opposite side of the terminal block.  This should take care of all possible scenarios.
Fozzy The Bear:
These really are a nice little bit of kit.... Nothing complex about them, or difficult to the degree that they couldn't be made up on a bit of strip board, but having one off the shelf for what looks to be about the same amount that I'd have to pay for the components themselves is very nice!

You can put me down for a 5V kit version one, with Blue LEDs please :)

Best Regards,
Julian (Fozzy The Bear)
Navigation
Message Index
Next page
Previous page

Go to full version