| Main > Main Forum |
| Router bits burning |
| << < (2/5) > >> |
| SirPeale:
--- Quote from: struby on March 17, 2006, 07:53:06 pm ---or you could just sand the edge, paint over it, or put trim over it. --- End quote --- He's not doing T-molding. |
| hypernova:
Correct. I'm routing out areas for my reunions on the top, and my other joys and leaf switches on the bottom. Lots of area to cover with a router. Still haven't gotten an answer to either query I posed. ;) |
| struby:
you can sand or dremel anything a router can cut. |
| nostrebor:
--- Quote from: hypernova on March 17, 2006, 07:03:21 pm ---I've read a bit of threads, but am a bit confused. I'm trying to rout out a 1/4" of plywood off my cp, and I've used the two straight bits I had access to. Both bits have burned/blackened in the section where they were cutting. They were both steel colored. I assume this means they weren't exactly top quality? Assuming I'm routing out a 5x5 sq. in. section, how long should it take? Two minutes? Four? Six? Longer? I need to know, since I've never used a router, so I really have no idea on how fast is too fast. --- End quote --- A pic would really help but based on your description I would guess that you are trying to take too much material at once, and going way to slow. I could route out a 5x5 area with a straight bit in about 30 seconds or less, especially if using a guide or template. I would take it in 1/8" deep setups. Do the whole thing 1/8" deep, reset to 1/4", then do the whole thing again. Hope this helps. |
| struby:
And also steel doesn't equal bad router bit, but most quality blades are diamond tipped I think, and are rather expensive as well. |
| Navigation |
| Message Index |
| Next page |
| Previous page |