Main > Main Forum
LED-lit coin button -- did I invent something?
<< < (2/16) > >>
MikeDeuce:
You guys are too kind :) Thanks for the comments and tips!


--- Quote from: mccoy178 on March 11, 2006, 03:38:38 am --- I'm curious to why you drilled the hole on the side and not in the middle? 

--- End quote ---

It was supposed to have two LEDs on opposite sides, that is, until I completely snapped one of the legs off my last LED of that size  :'(

Turns out one 800mcd LED is more than bright enough, though, so I'll be following your example methinks and remounting in the center, thanks :D


--- Quote from: whatzcrackn on March 11, 2006, 03:45:00 am ---Will this be on the up coming sheets?  And if so in different colors?

--- End quote ---

That's a good idea, might as well offer those up too, thanks :)
Santoro:
I'd buy that for a few bucks. Nice idea!
JoyMonkey:
Good job getting the vinyl aplied to the inside of the button plunger; that must have been tricky.
southpaw13:
I would buy some reversed sheets!  That would be cool to have 1 and 2 player led buttons! LMK when available to order....

Southpaw
psychopanda:
I'd probably mount the button down below in place of a coin door, but that's an awesome idea!  :)
Navigation
Message Index
Next page
Previous page

Go to full version